CAUTION: BE SURE TO UNPLUG SYSTEM FROM POWER SOURCE.

Touchscreen 01

  1. Turn off the power to your rewind system and unplug it.
    Touchscreen 02
  2. Use a flathead screwdriver to open the enclosure.
    Touchscreen 05
  3. Check the gray cable to make sure that it is plugged into the PLC and that it has not vibrated loose.
    Touchscreen 04
  4. Close and lock the enclosure and turn the power on to the rewind system.
    Touchscreen 05
  5. Turn the power on the touchscreen should be working. (If not proceed to the next section.)
    Touchscreen 06

Touchscreen 07

 

CAUTION: BE SURE TO UNPLUG SYSTEM FROM POWER SOURCE.

  1. Turn off the power to your rewind system and unplug it.
    Touchscreen 02
  2. Remove HMI cover and back plate on pedestal enclosure
    Touchscreen 102
  3. Make sure all wires are connected and are not loose.
    Touchscreen 101
  4. Reconnect HMI cover and back plate on pedestal enclosure
    Touchscreen 102
  5. Reconnect system to power supply and turn on the system. The touchscreen should be working. If not contact Web Techniques for further troubleshooting.
    Touchscreen 06

Touchscreen 07